Inprocess oral contribution to the ESTEC: Energy Simulation Technology Exhibition and Conference hold in Barcelona, from May 30th to 31st, 2018.
Inprocess contribution to the Aspentech’s hosted seminar entitled: The Rapidly Changing World of LNG: Finding your Competitive Advantage in 2018, held in Houston, Texas (USA), on March 2018
The associated gas of an oil-producing field in off-shore Brazil is treated to remove water, hydrocarbon condensate, H2S and CO2. For environmental reasons, the CO2-rich permeate stream from the gas treatment process must be re-injected into the reservoir.
Operator Training Simulators (OTS) have become an integral element of the Operator Competency Development Programs of the process industry. The dynamic simulation technology has evolved from the early days, incorporating new training functionalities and communication capabilities.
In a recent FPSO development project offshore West Africa, a lifecycle modeling approach project, ending in a direct-connect Operator Training System with Aspen HYSYS Dynamics, was used for process design and control narrative validation, procedure verification, ICSS check-out, control room operator training and support for FPSO start-up operations.
Producing plants must be safe and reliable. Plant Safety is strongly dependent on how well people responsible for running the facility (control room operators, CRO) are aware of its operation.
Process simulation is a technology used in many areas and project phases. Its usage ranges from the design stage of a plant (initial concept and front end engineering) to assistance in daily plant operations, including planning, optimisation and monitoring.
Joint oral contribution to Aspentech’s Users Conference Optimize held in Houston, TX (USA) in April 2017
Joint oral contribution to Aspentech’s Users Conference Optimize held in Houston, TX (USA) in April 2017
The definition of a Control System in Chemical and Petrochemical Plants requires specific know-how with the target of optimizing and improving existing systems and designing new ones. When designing a system, it is necessary to follow some basic steps such as modelling the system, analysing such model, designing the system/controller and finally
Inprocess Technology and Consulting Group, S.L.
Pedro i Pons, 9-11, 13th floor
08034 Barcelona, Spain
Tel: +34 933 308 205
© 2024 Inprocess Technology and Consulting Group, S.L. | All rights reserved
© 2024 Inprocess Technology and
Consulting Group, S.L.
All rights reserved
